- Home
- Services
Engineering services, end to end.
Three engineering disciplines delivered across the full lifecycle (design, supply and installation), plus facility maintenance for everything in your building. One accountable team, from the first drawing to the final service visit.
D-01 / Mechanical · Electrical · Plumbing
MEP & Building Services
The systems that make a building usable: cooling, power, water and fire safety. We coordinate them as one design, so ducts, cable trays and pipes fit together on site rather than clash.
HVAC & ventilation
Chilled water, VRF and split systems, ventilation, smoke extract and clean-air systems.
Electrical power
LV distribution, switchboards, standby generators, UPS, lighting and earthing.
Plumbing & drainage
Cold and hot water, booster pumps, sanitary drainage and rainwater harvesting.
Fire protection
Fire detection and alarm, sprinklers, hydrants, hose reels and suppression systems.
Medical gases
Oxygen, medical air, vacuum and nitrous oxide: manifolds, pipelines, outlets and alarms for hospitals and clinics.
LPG systems
Bulk and cylinder LPG installations, reticulation, regulators and leak detection for kitchens, laundries and industry.
Building management
BMS and controls integration for visibility and efficient operation.
Low-current systems
Structured cabling, CCTV, access control and public address.
- Design
- Supply
- Installation
- Maintenance
D-02 / Generation · Storage · Distribution
Energy & Solar
Lower energy bills and a supply you can rely on. We size solar, storage and backup power from your real load data, then integrate them with the grid and your generators.
Solar PV systems
Rooftop, carport and ground-mounted systems, grid-tied or off-grid.
Hybrid & battery storage
Battery systems that cut generator run-hours and ride through outages.
Power distribution
Transformers, MV/LV switchgear, power factor correction and changeover.
Energy audits
Metering and analysis to find savings, with a costed plan to deliver them.
Solar water pumping
Solar-powered borehole and irrigation pumping for farms and communities.
Monitoring
Remote performance monitoring with alerts and periodic reporting.
- Design
- Supply
- Installation
- Maintenance
D-03 / Water · Waste · Air
Water & Environmental
Safe water in, clean water and air out. We engineer water supply and treatment, wastewater, waste management and emission control for buildings, industry and communities, designed around local conditions and environmental rules.
Water supply & storage
Boreholes, storage tanks, reticulation networks and booster stations.
Water treatment
Filtration, softening, reverse osmosis and disinfection to the required standard.
Wastewater treatment
Packaged treatment plants and effluent systems for reuse or safe discharge.
Pumping stations
Pump selection, controls and telemetry for reliable, efficient pumping.
Environmental compliance
Support with environmental assessments, effluent testing and permits.
Rainwater & reuse
Rainwater harvesting and greywater recycling that cut demand on mains water.
Incinerators
Medical and general waste incinerators: sizing, supply, installation, commissioning and servicing.
Solid waste management
Waste segregation, collection, storage and disposal systems for facilities and institutions.
Atmospheric pollution control
Emission control, scrubbers, filtration and stack monitoring to meet air quality regulations.
- Design
- Supply
- Installation
- Maintenance
D-04 / Services · Environment · Fabric
Facility Maintenance
One contractor for the whole facility. We maintain all MEP and building services, all water and environmental systems, and the building itself, whether we installed them or not.
Planned preventive maintenance
Scheduled servicing against manufacturer guidance and your operating hours.
Breakdown response
A dedicated helpdesk and agreed response times, by priority, around the clock.
MEP & building services
HVAC, power, solar, plumbing, fire systems, medical gases, LPG and lifts.
Water & environmental
Boreholes, treatment plants, pumps, incinerators, waste and emission control.
Building fabric & finishes
Painting, masonry, roof cleaning and repairs, tiling, ceilings, doors and glazing.
Asset registers & reporting
Condition surveys, tagged assets and monthly reports in plain language.
FAQ Common questions
Before you call.
Can you take on just one stage, such as design only?
Yes. Many clients come to us for a single stage, such as an independent design, supply of equipment, or installation to someone else's design. Where we design and install, we can also take responsibility for performance.
Do you work outside Kenya?
Yes. We work across East Africa, including Uganda, Tanzania, Rwanda, Burundi, South Sudan, Ethiopia and Somalia. We mobilise teams from Nairobi and manage cross-border procurement and logistics.
How do you price a project?
After a site visit or a review of your drawings, we provide a detailed, itemised proposal. For larger projects we can price by stage, so you can commit to design first.
Can you maintain systems installed by another contractor?
Yes. We start with a condition survey and asset register, then put a maintenance plan in place. See Facility Maintenance.